|
ambercleared
Shot over the Krylon orange with clearcoat out of the HVLP gun in an attempt to keep the color from fading and the paint from chipping...
Date: 05/10/04
Views: 32
|
ambercorner
My version of the so-called "hyper amber" corners, done with Krylon Stained Glass paint (orange). A lot more work than the tails, the process is included in the write-up in the How-To section.
Date: 11/06/04
Views: 36
|
kolorvskrylon
House of Kolors intensifier on the left, Krylon Stained Glass on the right. The krylon is sanded and polished, and also chipping ot hell after about 3 months. The Kolor is untouched, only about 3 hours out of the gun. As usual, the photo does no justic
Date: 05/10/04
Views: 34
|
newredout
My "new" redouts, these done with Krylon Stained Glass (red) and no clearcoat. Processed the same as the amber corners, also described in the how-to.
Date: 15/05/03
Views: 31
|
|
newredout2
Took the time to sand down the clear on the old set... then paint over them with the Krylon, and go through the sanding process again. All I can say is... Damn. The picture doesn't show it very well, but the red is just plain dark.
Date: 15/06/04
Views: 44
|
rearquarter515
These are my first redouts, done with Testors Candy Apple and Plastikote Clearcoat. I wetsanded the Testors well enough, but apparently didn't get the clear finsihed well enough, because after just over a year, the clear started to chip. Testors
Date: 15/05/03
Views: 19
|
|
|
